To Top

Flattie Project Clinton, UT **SOLD**


UPDATE: **SOLD** Was on eBay.

It appears the builder lengthened the body but forgot (or not) that the top would be too short to fit.  So, naturally, the solution was to bend the windshield back.

“Built CJ2! The body has been lengthened and the fenders widened.  It sits on two Dana 44 front axles giving it front and rear wheel steering, warn hubs, turbo 400 trans, 13in wide rims, link and spring suspension, equipped with drum brakes front and rear.  There is a hole in the hood where the air cleaners from the previous motor poked through.  This rig has been garage kept for the last 30 yrs and properly coated to protect it from rust.  The gas tank has been relocated to the inside rear of the vehicle. NOTE: This is a non running vehicle there is an engine included.  The vehicle is located in Clinton Utah buyer arranges transport, vehicle does come with a tow bar.  !!Engine included but not installed!! The engine is a Chevrolet 327 from a 1966 corvette that was rebuilt 10200 miles ago.”


Leave a Reply

Your email address will not be published. Required fields are marked *

Subscribe without commenting