UPDATE: Still Available

(10/22/2013) Lots of updates to this flattie.

“I have a 1946 MJ flat fender jeep that I have for sale. Its originally from Arizona which means the actual body is in great shape a little surface rust but not much. The motor is a crate 327 coupled to a turbo 350 transmission. The flowmaster exhaust sounds awesome. Does not have a transfer case so it is 2wd. I’ve been told the motor only has a couple hundred miles on it. It has been sent to me from my family in arizona. If you know anything about these jeeps you will understand when I say im 6’3″ and frankly dont really fit in it. sitting on brand new 33x 12.5 radial svt tires. I would consider it to be more of a hot rod then a jeep but to make it a 4×4 just put a transfer case in and your set. It does have collector plates on it now but other then starting it and letting it warm up it doesnt get used so I figure its time for it to go. If you have any questions email me and ask and I will do my best to answer any questions.”

http://seattle.craigslist.org/tac/cto/4256043301.html

UPDATE:  **SOLD** Was $2000.

Runs, but no title.

“1947 Jeep Willys was being build for a mud race truck, but don’t have time for it anymore. Asking $2000 or will take best offer. Runs, no title bill of sale only, Tires do hold air would be Great for Deer lease hunting buggy. ”

UPDATE: Was $2500. **SOLD**

Runs and drives.

“This is a 1947 Willys CJ2A. It is running and driving. The distributor is totally worn out and we plan to replace it when the new one we have on order shows up. The steering is pretty worn like most of these are. It has been sitting for a while and the brakes will most likely need bleeding. It will need a 12 volt battery and fresh gas. The 4×4 works fine and the motor holds 30 to 40 psi oil pressure. It has been patched here and there on the body but looks pretty decent.
We are not interested in trading for cars, trucks, livestock, Boats, or ATVs. I will consider other willys jeeps. Bring cash and the jeep will come with a bill of sale.”

UPDATE: **SOLD** Was $4800.

(12/21/2013) I wonder if that windshield is a modified 2A? Looks like the front clip has been stretched pretty cleanly.

“1948 Willys body on 1979 Jeep frame, rebuilt 360 jeep motor. 38.5 tires, Been parked in garage for years and finally ready to sale. Call with any questions,”

UPDATE: **SOLD* Was $4200.

The drive train’s been updated.

“1946 Willy’s CJ2. 1992 4.3 liter V-6, 4 speed, rebuilt transfer case, front and rear end stock with lockers in rearend, 538 gears, runs good. New tires and wheels. Decent full canvas top, nice seats. Good for hunting. $4200.”

It runs.

“For sale is a 1948 Willys CJ 2A NO TITLE this is a project engine runs with 50 pounds of oil pressure on the dash gauge. Transmission shifter will not move out of neutral. Transfer case shifts from Hi/Low and in and out of 4×4.”

http://stlouis.craigslist.org/cto/4273284671.html

Assembly required.

“For sale is a ’47 cj2a for sale. It is a rolling chassis and includes new parts such as: body tub,fenders ,hood, grill, gas tank, painless wiring harness, seats, 12 volt conversion kit, brakes, brake lines, exhaust system, choke and speedo cable, professionaly rebuilt 134ci motor and tranny/trnsfercase, steering wheel, lock-right rear locker with new ring and pinion (5.38), axle seals and bearings, leaf springs, shackles and u-bolts, front bumper, clutch assembly, motor and trnsmission mounts, etc… It has been garage kept and needs a new home for finishing. Ask for Brian.”

http://tulsa.craigslist.org/cto/4273958684.html

UPDATE: Price dropped to $3500

(12/15/2013) Seller does not have a title, but has a replacement title form.

“While driving down a street, we spotted an old dusty willy’s jeep. It belonged to a widow’s husband and was sitting for many years collecting dust near the back of her house. We were told that the jeep was running until he passed and it sat since 2010. It is in good shape for being a 67 year old jeep! It has a 327 with aluminum intake and camel bump heads, automatic transmission, a removable tow bar, a front windshield that smoothly tilts, and locking hubs. There is a rack to hold two Jerry cans. The body and the floors are surprisingly solid and there is only a small amount of rust on the driver’s side, which is an easy repair. There is a removable tow b

We were given a signed DMV Title Replacement form, so one just has to go to AAA or the DMV to get a new title.

Sold as is. Call (310) 309-1294 to make an appointment to see the jeep or if you have any questions.”

http://losangeles.craigslist.org/sfv/cto/4273619221.html

UPDATE: **SOLD** Was $1200

“I have a 47 willys cj2a I would like to sell or trade. it is running and driving but is a project that needs finishing touches. i am selling cheap because I don’t have any papers for it right now. not that hard to apply for a lost title and get everything signed into your possesion. woulld.like to trade for an AR 15 chambered in .223/.556 , or a .204 ruger, or a glock model 23/27/30 plus cash or an Fn 5.7, maybe other trades just ask. also interested in winches for.my trucks, a grey set of buckets with center console for an older powerstroke, other powerstroke parts, a protech headache rack for an f-150, maybe a lift kit for an 88 f-150 or a 95 f-350, a nice bow or muzzle loader, or a pit bike. my phone number is 253-307-4873 jeep has a 289 v8 mild build with a 3 speed manual, dana 20 twin stick transfer case and advance adapter. dana 27 front axle with warn hubs, ford 8.8″ rear. both have 3.73 gears. nice roll cage, fuel cell, bucket seats, custom center console that holds 2 batteries, toolbox built in the rear,stainless dash, electric fan, winch ready, custom bumpers, tow bar, new clutch, new exhaust gaskets, new u joints, new plugs, wires, good battery, starter, alternator, new exhaust, comes with a hard top that could be refurbished. tub has been notched to fit a taller person, tilt steering. great jeep to fix up. probably more I’m forgetting. needs little finishing touches such as brake lines bled, tuck a few wires, and maybe replace a guage or two. blinkers, tail lights, horn and brake lights all work!”

UPDATE: **SOLD** Was $600.

Hard to tell how much value is here.

“47 willys CJ-2a. No title, will provide bill of sale, all vin tags intact. Overhead f-134 engine, t-90, dana 18 twin stick transfer case. Was complete until I took off some hoses and generator and starter for another project. I do not know if it would run. Before I took off some parts I did check and it had compression. Motor spins freely, trans and transfer case shift smooth. Has 5:38 gears. Body is very rough, seats are just sitting in the jeep and are not original and torn. 5 matching older tires nylon 10 x 16.5. Front frame horns have usual ugly gusset ing. I would keep and look for another body or for parts but space is limited. $600 firm.”

UPDATE: **SOLD** Was $5900

(05/16/2013) I think by 3 speed overdrive the seller means high range?

“Flat fender. WWII square split windshield. Military insignia. Mostly original with higher power CJ3b Hurricane engine (F-head, intake valves in head, 53-71) and air scoop. 12V electrical. Desirable 3-speed Overdrive for freeway driving. Hi-Lo transfer case. 2 or 4WD. Always stored inside.

All new parts and accessories. New 235×15 tires mounted on off-road wheels. New front seats. Rear buddy seat. 2 canvas tops and back curtain. Everything works, including heater & fan! Simple and reliable. Starts every time without choke. Runs great! Economical! Fun and cool to drive!

You can get a Wrangler for the money, or you can own a piece of history and show off your personality with this! 125k documented miles. Current registration. It has already lasted longer than most people! May take a trade with at least $3000 in cash. Serious only please. (No reply to software generated “Is it still available” to get address for spams.)”

UPDATE:  **SOLD** Was $4500.

Looks solid.

“1947 Willys jeep. Very good condition. Runs great. Fresh paint job.”

UPDATE: **SOLD** Was $2200

(08/31/2013) It’s a project, but it looks in good shape.

“1948 Willys CJ2A 4×4 Project, Has a chevy 283 bored 0.30 solid lifters, wiend stealth intake, Mallory magnetic breakerless ignition and Mallory super coil, 33″ tires and super single style rims 15×10, keg converted into fuel tank, rancho shocks and lift, 2 sets of seats one set plastic molded and the other is out of an Acura.

This motor ran super, I have since used the carb and battery on other projects, it has a broken rear axle so it will need to be trailered even though it has a tow bar attached to the front, all in all I’ve had it garaged since 1995 when I bought it. This is a good base for off road fun, the motor ran strong and loud with a definite lope, turns head even on the trailer, contact me with any questions more than happy to talk about the mods that have been made.”

UPDATE: Still Available

(04/26/2013) This includes an overdrive. It’s listed as a ’45, but I don’t see anything to indicate it’s that early. The body is a little rough based on the old pics.

“Here we have a 1945 Military Willys Jeep. 283 Chevy V-8 engine. 3 speed manual transmission with overdrive and a dual stick transfer case. New lock out hubs. Runs and drives great. Asking $3650 OBO. Layaway type payment plans available. Call 719-243-4614”

http://denver.craigslist.org/cto/4269627958.html

Not a lot of value here.

“41 willys jeep cj2a. rebuilt flat head 4 cyld engine with less than a thousand miles. drive train pretty good condition. needs to be put back together or used for parts.”

http://macon.craigslist.org/cto/4267909051.html

UPDATE: **SOLD** Was $2700

This is a project.

“I am trying to sell my 1946 willys jeep cj2a. I have about 3200$ invested in it and the time has come that I just need to get rid of it. It has a 350/sm465/np205 with full width axles that are Dana 44 front and Dana 60 rear. It has a warn xd9000i winch that goes with it the tires are 33×12.50r15 super swamper tsl thornbirds that are about 30-40%. The 350 was just gone trough and cleaned up 2.02 heads with roller rockers were put on it with an edelbrock intake and edelbrock carb the trans shifts really solid and the trans was just cleaned up also. It is a project for sure all the main pieces are there and it will come with a set of 4 Cherokee coils to switch the suspension from leafs to coils front and rear it needs this because the rear axle has been moved back about 8″ to make room for a longer rear driveshaft. It will need a starter, wiring harness, seat belts, links with heim joints, drivelines, and a radiator so it’s only about 1000-1500$ away from being a driver and I am in school and can’t afford this at the time”