UPDATE: **SOLD** Was $650.
(01/03/2011) “1949 Willys Jeep, needs complete restoration.”
Includes a rear PTO. No pics provided.
“For sale is a Willys CJ-3A jeep. No title, no motor. Body is fair, frame is pretty good. No seats. I was going to rebuild it, but, too many projects “on the fire”,,, I also have a bunch of Willys parts for sale, including flat head motor,(would work in this CJ-3A) rear PTO, body parts (for CJ-2A and CJ-3A, and a few CJ-5), small parts, seat frames, parts for a M-38A1, a fully rebuilt flat head motor, small parts, gas tanks, gauges, rear draw bars, roll bars,,, Love to sell it all as a package.. I am also planning on selling some restored CJ-5’s in time. Thanks !”
UPDATE: **SOLD** Was $2500.
The seller wants to make a trade.
“I am selling or would like to trade for a car or rv the jeep has a f134 motor in it a t90 trans t18 t case 538 gears and a 8000 pound winch runs great. for more info please email me with pics of the trade and info”
No pics provided.
“1951 Jeep Willys needs someone with time to love her back to health. I bought form the original owner and I have the title ran when last parked. All original including the spiders.”
UPDATE: **SOLD** Was $3000
(11/14/2010) “I have for sale a 1950 Willys CJ-3A in close to original condition. Sold with clear Oregon Title. This vehicle was in use by the Butte County Mosquito Abatement department in California since the mid-fifties. The last entry on the maintenance record shows 70,302 in 2005 but when I got it the speedometer head was frozen so Im not sure of the exact mileage. Since I have owned it I have put an additional 1,200 miles on a new speedometer. It always gets lots of attention and questions/comments from vintage Jeep admirers. The engine was replaced at 54,970 in June of 1972 with a CJ-3A engine #3J20172. The vehicle still retains the original 6-volt electrical system. Since I have owned it I have replaced the clutch, throwout bearing, pilot bearing, clutch linkage, fuel pump, fuel tank, fuel lines, and vacuum lines. The transmission and transfer assemblies have both been rebuilt along with the carburetor. I have replaced the center tie rod end assembly and rebuilt the drag link with new parts. I have installed new upholstery for the seats and backs along with new seat pans and seat belts. The canvas top and hardware will not be included as they belong to another project I have started. There are two areas where rust needs to be addressed. 1. The passenger side hat channel. 2. At the rear of the drivers floor area behind the fuel tank. I have replaced the tailgate and hood with new ones that have the Willys stamped logos. I’ve tried to be as complete in my description of this vehicle as I can and can honestly say it is a dependable vehicle. Please feel free to call if you would like to inspect this great little rig. Thanks for looking. Please feel free to ask about anything that concerns you regarding this vehicle.”
It runs and drives, but definitely needs work. http://www.cj3a.info/sibling/cjv35u/photos/picsv35.html
“For sale is a 1950 Willys Military Jeep. It is a CJV35/U which is a specialty jeep made for under water use for radio equipment. It is known as the rarest military jeep in the world with just 1000 manufactured. Only about 50 are still in existence. This is a project jeep for sure. It runs and drives but is in rough condition. Again this is a project jeep for a military jeep enthusiast. It has all of the original drive train including the Flathead 4 cylinder engine. I have not started the jeep in a year but I can get it started. To learn more about these jeeps please visit this link where you will also see this jeep. Thank you for looking. 713-882-1012”
UPDATE: **SOLD** Was $6000
(12/22/09) Lots of good quality customizations here.
“1948 body & frame. Mid 80’s CJ5 axles. Front Dana 30 w/ shackle reversal. Warn locking hubs. Rear AMC 20 Summers Bros. hardened racing axle. Dana 20 T/C. 64 Buick 3.5L 215 cu. in. aluminum V8, Mallory ignition, coil. Saginaw 4 speed transmission. Cylinder head work, new cam & lifters. Edelbrock intake, w/ Holley truck avenger carb w/ elec choke. Headers & Flowmaster exhaust. Warn 8K winch w/ remote lead. Custom front bumper w/ lights. Custom stainless steel rear bumper. Entire body LineX. New seats. Painless 12 circuit ATO harness. Full roll cage. AutoMeter gauges. 12 gal Harwood racing fuel cell w/ elec fuel pump. Goodyear Wrangler M/T 33X12.50R15 (Hummer tread pattern). Outlaw style alum rims 15×8. Extra engine & parts for another complete engine.”
UPDATE: Price dropped to $5500
(04/16/2010) “1950 CJ3A JEEP 2ND OWNER IN 61 YEARS.THIS JEEP HAS RECENTLY HAD A WHOLE BUNCH OF RESTORIATION DONE. CALL ME FOR MORE INFO : RALPH 541-680-2060r email mcguffie1 [at] yahoo.com.”
UPDATE: **SOLD** Was Make Offer
It’s rough.
“1953 willys jeep.body is rough.quit running over 30years ago and just sit ever since.has locking hubs.have title,make offer”
This has some mods, but hard to tell just how much.
“1958 Jeep Willys for sale on Johns Island. Runs good all selas have recently been replaced. Great for the farm. Clean title. Email or call 708-4223 with questions.”
UPDATE: **SOLD** Was $3500
“-283 V8 w/headers
-3 speed w/all-range overdrive
-5.38 axle ratio
-full roll cage
-skid plate
-tow bar
-tilt/telescopic wheel
New battery, new alternator, rebuilt carburator. No leaks, no rust, no doors, no heater, no power anything. I previously invested over $7000 in this, but then it sat in a barn for ten years. It’s running like new again, but the tires are old, and it still needs brake work. This is a turn-key, mostly complete, running jeep for the price of a project jeep. Clean title, but currently registered non-op. Make offer.”
No pics. Unsure what it is.
“50’s jeep Willys not sure of the exact year. No title, No motor. Great for parts.$350.00
Call David @208-861-5151”
No pics provided. This sounds like a flattie built on a ’66 CJ-5 powertrain.
“Jeep was completely rebuilt 12 years ago with a brand new steel body, full roll cage with seat frames tied into cage. 225 cu. in. V-6 engine, trans and t-case out of a 66 cj-5. Pwr steering out of a cj-7. Stock suspension. stock 16″ wheels with radial snows.
Garage kept, no rust. Sorry no pics yet.”
UPDATE: **SOLD** Was $3000.
This is rough. Strangely, the two connecting bars between the front and back loops of the roll cage were cut out. You can just see where they were on both loops.
“1953 WILLYS
BUICK V6
MUNCIE 4SPEED
2 SPEED TRANSFER CASE
$3000”
The seller accidentally lists this as $2000, but it’s really 20,000. No pics provided.
“6 YEARS TO ENGINEER & BUI LT 307 Chevy 210 HP OFFY Manifold &625 carb hubs all around-538 R&P
44 REAR w/ARB — 30 FRT POWER LOCK
Q78-15 Swapers , dual batteries electric fan
3 SPEED W/OVERDIVE,aux Radiator & Oil cooler
Dual Ranco 5000 all 4 corners,PS-PB.. tilt-tele streeing 5 point 3 inch Harness
FRONT-REAR 5000 LB WINCHS..traction bars
Truss Bars front an rear..10 AUTO meter gauges
6 Step Sequential ignition> ELECTRONIC IGNITION
Hella 100 w fog–Hella 100 w flood–CIBIE 100 W DRIVING
HELL YA ITS EVEN GOT RACING BUCKETS SEATS
runs – fine to many extars to list boxes of left overs lol….
20.000
YES I HAVE PICTURES BUT ONLY TO BUYERS MUST SEE TO BELIVE 20.000”
UPDATE: **SOLD** Was $3300.
Truly, one of a kind paint job.
“1951 Willys Jeep CJ3, powered by a 1966 Buick V6 engine. Three speed, lock out hubs. Most of it is original with exception of the engine and the seats. In decent shape but needs some TLC at this point. Hasn’t been started in a while but last time I used it it ran strong. Haven’t had time to do much with it over last two years and basically it’s just been sitting in the garage. Pretty much garage kept ’til about 3 weeks ago. Recently moved and decided to sell it ’cause storage space is now an issue. It has a title. Not looking to trade – just looking to sell. $3300 or best offer. ”
UPDATE: **SOLD** Was $2500
There’s been some updates to this jeep.
“1951 CJ 3A Willy’s Jeep for sale. has a 289 V8 68′ Mustang engine inside of it. 4 wheel drive works good T18 Trans. Must see! Registered with pink ready to go! Asking $2500 OBO.”
No pics provided. Not sure what is here.
“good for parts or fix 2 motors call 646 7100665 send e mail its better motor in jeep is set siezed ran numbers on web said its a 59 i think its military due to bull bar and widicker cables”
UPDATE: Price dropped to $900
“I have two Willys Jeeps both are CJ3A. Asking 900 dollars for both or make an offer individually. Both have orginal 4 cyclinder engines. Great project jeeps, just do not have to the time to work on. them.”
UPDATE: Was $6500. **SOLD**
This looks like it might only have 30,827 miles.
“1949 Willys Jeep 30,827 Miles…. Asking 6,500”
UPDATE: **SOLD** Was $4300.
(03/13/2011) Not much info. It appears solid.
“my dad has had this for 20-25 years.He just passed away I need to sell it to pay some things. Good tires runs good frame and body in good shape soft top also”
UPDATE: Was $8500. **SOLD*
(08/07/2010) Actually, not a bad price.
“2 Door, Convertible, 4 Wheel Drive, Manual Transmission, Alloy Wheels, New Tires, Removable Top, Bucket Seats, Leather Seats, Power Steering”
UPDATE: **SOLD** Was $1800.
It seems to run and drive, though I suspect this has seen a few swamps.
“1949 JEEP WILLY…………. $1800/OR TRADE FOR TRUCK……4X4…. RUNS GREAT!!!”
UPDATE: SOLD: Was listed at $3000.
(09/16/2009) “1952 willys jeep in execelnt condition custom wheels, 18800 miles, is a jewel, runs great, no rust, and Original color (banana yellow), the motor is a 1960’s overhead valve came originaly with a flathead. this is the only thing not original.”
UPDATE: **SOLD** Was $500.
That looks like a bobcat body.
“Hi there , I’m selling my Fiberglass bodied Willys project Jeep. Basically this is a good start for a build up or switch the Body over to one that has rust issues or damage ? No Engine/Trans/Transcase/Windshield frame/etc. Rig comes with Fiberglass Tub,Diamond plate corners, Hood, Fenders,Chrome Grill,Stock frame,Axles,Springs w/small lift,Tires & Wheels and some misc. odds and ends. No title , but I will be glad to give you a bill of sale/release of interest.”