UPDATE: **SOLD** Was $5000
No obvious rust.
“47 Willys Jeep CJ2A – Flat head 4 cylinder, runs good
Ready for hunting season, asking $5000 (evergreen area)”
UPDATE: **SOLD** Was $5000
No obvious rust.
“47 Willys Jeep CJ2A – Flat head 4 cylinder, runs good
Ready for hunting season, asking $5000 (evergreen area)”
UPDATE: **SOLD** No Price.
Various parts.
“pto winch,original equipment,with willys mounting bracket,rebuilt transmission,hay bed,new clutch, pressure plate,rims,misc parts,”
UPDATE: **SOLD**
Here are a couple body panels from the 1970s.
“1952 WILLYS CJ PARTS
RIGHT REAR PANEL $175 OBO
RIGHT FRONT PANEL WITH STEP $150 OBO
ALL ORIGINAL JEEP PARTS BOUGHT IN THE 70’S”
UPDATE: Was $800. **SOLD**
(09/02/2013) No title.
“46? WILLYS JEEP CJ2A CIVILIAN MODEL 4X4 HAS CHEVY V-6 ENGINE. THIS IS A PROJECT WITH NO TITLE. IT NEEDS A LOT OF WORK TO BE ROAD WORTHY. RUST IS NOT BAD FOR A MISSOURI VEHICLE OF THIS AGE. DOES NOT RUN BUT WILL TURN OVER AND FLUIDS LOOK GOOD. WOULD BE A GREAT HUNTING VEHICLE OR OFF ROAD TOY. I ALSO HAVE AN ORIGINAL CJ2A FRAME COMPLETE WITH ENGINE AND RUNNING GEAR WHICH IS NOT INCLUDED IN THE SALE OF COMPLETE JEEP. FRAME IS VERY RUSTY, ENGINE TURNS FREE. WILL SEPARATE”
There looks like value here. That’s just like one of my seats, but it has the original cover on it.
“I have a 1948 cj2a tub grille hood fenders and tail gate. Comes with title and collector plates. $300”
UPDATE: **SOLD** Was $5250
(08/26/2013) This looks like a nice build for the price.
“-Rebuilt L-134 original engine, less than 2,500 miles on rebuild
-Rebuilt axles (Dana 41), transmission(T-90), and transfer case
-538 Gears
-11″ Brakes (new with rebuild)
-Tiger Top
-New Fuel Tank
-New tie rods
-New tires P235/75/R15
-New exhaust
-Several gauges/speedo replaced
-And the list goes on…
This is a fun jeep, that just needs to be used and not sitting in my garage. Way too busy to give it the attention it deserves. This was a fun project.”
UPDATE: **SOLD** Was $4000
(07/05/2013) This needs a wiring harness.
“This is a 1948 Willy’s CJ2A Flat Fender 4×4 Jeep. It looks like it was fully restored in the late 80’s. NO RUST!!! It has a Chevy 350ci Carbureted Engine out of a 70’s Chevy C10 truck transplanted in place of the anemic 4 cylinder these originally came with. The frame has been fully boxed in order to support this HP increase. The motor runs perfect! It has the original Borg-Warner T90 3-Speed Transmission and the original Dana Spicer Model 18 Transfer Case. It also has fairly new wheels and tires, long tube headers, soft doors, aftermarket bucket seats, Pontiac tilt steering column, Warn manual locking front hubs, and dual gas tanks.
For a 65 year old Jeep it is in awesome condition. These old Willy’s are getting extremely hard to find and will continue to increase in value. I bought this as a project and have completely removed the wiring harness. This would make a great father/son project. I am not in a hurry to sell and the price is firm. The only reason I am selling it is because I don’t currently have enough time to work on it.”
UPDATE: **SOLD** Was $1250
(08/09/2012) Here’s a rare project Surrey.
“1964 Jeep Surrey Gala(DJ3A) 2 wheel drive version of the CJ3. Unique model, not very many made. Has the 134CI flathead that runs pretty good. This model has the 3 speed stick shift on the column instead of the floor. This Jeep has already been soda blasted and is ready for restoration. Would be a good father/son project.”
UPDATE: Still Available.
(08/24/2012) This is a former railroad FC.
“Rare Jeep FC 170, Runs great must see to believe. 6 cylinder, 3 speed 4×4
Open to reasonable offers. Will take possible trades and cash.
LOOKING FOR A 1965 or 1969 GTO project car.”
UPDATE: **SOLD** Was $900.
(07/14/2013) I *think* these are both for $1000.
“I have two Willis jeeps two motors
One metal roof
One jeep is a cj3b”
I’m taking the sunday off. We had a long, but beautiful drive Friday. We found jeeps, great food, and beautiful scenery. If you ever have the time, I highly recommend the trip from Randle to Trout Lake and Beyond.
Below, I’m learning about the finer points of barbed wire. Yes, those are all different strands of barbed wire. A complete report (and more jeeps) tomorrow.
UPDATE: Steve noted that we passed Trout Lake, not Troutdale. Given our successful drive, I can verify his correction 🙂
Ann and I are traveling to Seattle today, but instead of taking our usual route over Snoqualmie Pass, we decided to do some exploring while the weather is nice.
So, we plan to go along the southern area of the state through some towns (Bickleton, Glenwood, and Troutdale) where neither of us has explored. From Troutdale we plan take forest road 23, which winds through the Cascade Mountains, to Randle. We thought this would be a good opportunity to explore the area for future camping trips.
To give some perspective, normally it is a three hour, 173 mile, trip from Pasco to Randle. Given we’ll be stopping, driving slowly, etc, we be much longer.
Here’s our expected path. The dotted lines from Bickleton, where there is a carousel museum of some kind, indicates a cutoff we hope to make to Highway 97 and Satus Pass. There we want to have lunch at St. Johns Bakery. It’s a well regarded food stop in the middle of nowhere that’s part of the St. John Monastery.
I’ll report on Saturday night if we made it (or not report if we didn’t make it out . . . lol)
Here’s a 1954 ad that features a couple of Willys vehicles.
“1954 Wafarm Murrayville IL Willys Truck Cedar Brook Farms Prospect KY Jeep Print Ad
Original vintage magazine advertisement. Page size approx 7 3/4″ x 10 3/4″.”
Looks good.
“This is a Nice M38A1 Military Jeep, 24V Runs and drives great. new paint, Tires, New Canvas seats / summer top. I have a full list of the new parts we just put into the Jeep. $7700.00 call 701-seven 3 nine – four 9 0 nine”
Looks fun!
“Race jeep, 4.3 chevy,14:1 compression,solid cam,ported heads(vortec),demon carb,automatic,Dana 300,champion bead locks with pro comp mts(all new), one piece fiberglass body, lots of parts and extra sets of wheels and tires”
UPDATE: **SOLD**. These were listed at $2500.
“For sale two 1942 ? GPW ford WW2 jeeps .I was going to part out both Jeeps as they are loaded with original F marked parts ,but in my opinion both rolling frames are way to nice to be parted out and a great start to someone restoring a WW2 Ford in need of an original rolling frame or original tub. The first frame is in excellent original condition with lots of original paint and correct running gear . Frame id number is GPW101852. Machine gun mount ,original springs ,rear pintle hook and bumper gussets all there.
The second frame is also very respectable for its age with lots of original paint in tact . There is one area in need of repair in back of rear drivers side spring ,which was a common problem area on these jeeps. Can easily be repaired. ID number on this frame isGPW69089 with a star after the last number.
Both tubs are there but in need of replacement floor panels and some work . I have definitely seen much worse brought back to life. On the greenish looking tub there is an excellent pair of original F marked fenders and hood ,along with a decent drivers and passenger seat frame. There is also a rear seat frame that is rough at best .The Blueish tub is about the same with original fenders not as nice, but a very decent hood. There are no grilles included ,no body tags ,and widshields are rough. also no gauges. There is also one correct T84 transmission – transfer case with e brake assembly included ,and one good running motor .It has a GPW stamped head but not sure if its just the head or a military motor. No carb. Basically what you see in pictures is what you are getting and anything else I can find related.
$2500 for all of it.”
This has quite a few updates.
“1958 jeep willys overland wagon. Freshly redone rustfree body from Oregon. Chevy 383 stroker engine,balanced with an rv cam. Turbo400 automatic with Dana 300 Scout twin shifter transfer case. Power leather drivers seat. Tilt steering wheel.Rare barn doors with rounded rear wheel wells.Runs and drives nice.New 33×15 BFG all terrain tires .Needs some intertior finishing. Call 612-701-9214.”
Josh forwarded this ad. At least part of this looks like a V35.
“I have one Willys Jeep that has a tooth missing on the flywheel and needs a carb rebuild. It is sound other than that. The other Willys is strictly a parts vehicle. Has a short hardtop with metal doors and roof. Complete engine and transmission. Will sell both for $2,000. I am negotiable on price.”
UPDATE: **SOLD** Was $3500.
It appears solid.
“Mostly original with flathead 4cyl. Runs great and driveline solid. Needs brake work and the body needs is what you would expect from a ’49.
sking $3500 obo and will take offers for 2-3 weeks.”
UPDATE: **SOLD** Was $650
The engine runs. Might be worth a look.
“1953 Willys CJ3B – restoration project, engine & drive train work, everything else needs lots of TLC. $650.00 obo – cash only”ml
UPDATE **SOLD** Was $2900.
It’s been highly modified.
“1945 Willys Jeep for sale. $2900.00 Firm
TJ Wrangler Bucket seats, Tilt Steering, Straight 6 Ford 200, 33″ tires and Aluminum Rims, New Clutch, Pressure Plate and Throwout Bearing, Tow Bar, Toyota Axles, Soft Top, Spare windshield and Windshield Frame, Extra Front Fenders, LED Tail lights and LED Marker Lights
Runs Excellent!!”
I wonder how long this has been sitting outside.
“1948 willys jeep red soft top collector item rare 4×4 also has all soft tops”
UPDATE: **SOLD** Was Make Offer
There appears to be some value here.
“Project!!!! 1942 Willy’s Jeep
Compete engine transmission
Transfer case and clean title
Make me an offer..”
UPDATE: **SOLD** Was $1450.
It’s a project.
I have a nice project for the jeep fan .. its mostly all there ..great fenders .hood.grill.head lights .one front seat .back fenders are solid . Some rust holes in floor pans . Mostly under seat area and where the original wood frame was ..its painted to prevent more rust . The windshield fram is intact but no glass with some small rust holes along bottom ..the frame appears to be real solid.. axles and running gears are there along with tranny and drive shaft..the motor is apart and stuck needs rebuild I’m working on getting it unstuck and completely apart ..really a good resto project ..the good thing its mostly complete ..its got all three number plates but i have no title .. in tn you can file for one if you need it or use it for parts ..asking 1450.00 or best offer”
No pics provided.
“THIS OLD COLLECTIBLE IS IN TURN KEY CONDITION!!! ONLY SERIOUS BUYERS ONLY
PLEASE FOR DETAILS,
CALL/OR TXT
MATT (417) 658-36FIVE FIVE”