A ran-when-parked 3A.

https://www.facebook.com/marketplace/item/606433244332584

“I am selling my 1951 CJ3A. I am the 3rd owner but it has been sitting for over a decade and was told it ran when it was parked. I have replaced most of the wiring, gauges, and gas tank with accurate reproduction. Wanted to restore it and get it driving but ran out of time. Besides what I have changed and the wheels/tires the vehicle is still original as it came off the factory floor. Also still has the VIN plate which is very rare for an old Willys. Asking $8k because of the rarity and original VIN plate.”

It runs, but may need brakes rebuilt.

https://www.facebook.com/marketplace/item/916395209317848

“Very original 1950 CJ3A. -Tight L134 Go Devil engine with brand new valves and guides. It doesn’t smoke and has good compression. -Comes with a brand new full brake rebuild kit from Walcks Jeep Parts. -It has a brand new set of bias ply tires. -Body is pretty dinged up from years of use, but it has basically no rust. There is one rust spot the size of a dime on the passenger side. This Jeep is a project. You will have to trailer it home. I’m sad to sell it, but I’m moving, so its got to go. Located in Trinidad, Colorado. Cash only, no trades.”

UPDATE: **SOLD** Was $2000.

Parts or project.

“It’s been sitting for years, make an offer”

This runs and has a pretty large front bumper.

https://www.facebook.com/marketplace/item/370516405231229/

“51 , runs and moves , extra good frame with axels no rust . Two extra good axels . Good T90c yes it’s a C and clean inside , one chip on one gear but had someone look and said it would work just fine . Transfer case is good to . Top I got a few years ago just never did anything with it . The 52 has no rust . And a jerry can and holder not shown”

Thanks to Pete for sharing this one.

https://www.facebook.com/marketplace/item/376033394615956/

“1953 turns over but won’t start clean title needs restored project that’s it bill of sale the jeep needs front seats has back one it’s off of dmv but can be Registered my mechanic told me was the timing but sold as is you need a trailer or tow truck”

It’s a project that needs work.

https://www.facebook.com/marketplace/item/770421960615777/

“This is a great summer project motor runs but needs some work no computer to worry about this is old school Holley 4- carburetor 350 Chevrolet motor very nice”

UPDATE: **SOLD** Was $4000.

(06/13/2022) This has an unusual steering column mount.

“1952 cj3a (willys) has a 351 Windsor auto trans 97%rust free tank needs cleaned and front wheel cyls are leaking have kits to rebuild 5000 obo dropped price it needs tires or trade for another jeep”

UPDATE: Price dropped to $13,500.

This looks solid; it has some minor mods.

https://www.facebook.com/marketplace/item/1061402431414520

“this is a 1953 willy jeep it has 32,000 original miles. runs and drives smooth. 3 speed everything works on it.”

Only the one pic provided. It looks like the driver’s rear wheel-well has been modified.

https://www.facebook.com/marketplace/item/376033394615956/

“1953 turns over but won’t start clean title needs restored project that’s it bill of sale the jeep needs front seats has back one it’s off of dmv but can be Registered my mechanic told me was the timing but sold as is you need a trailer or tow truck”

UPDATE: **Sold**

This is a REALLY well done build. The customizations are clean and simply executed. David has a clear title, but the serial number appears to be from the previous L-head engine (not uncommon).

The only issue with the jeep is that the hazards are staying on when the jeep is running. The switch to turn them off isn’t obvious (unclear where that is).

Here are the specs as best as I could determine:

It is a CJ-3A based on the body and the frame
Buick V6 (most likely a 225)
12 volt system
3 Speed (T-14?)
Dana 20 transfercase (single lever)
Custom radiator
Power Steering
Tilt Steering wheel (possibly out of a Cherokee jeep?)
Dana 30 front (most likely)
Dana 44 rear 30 spline axle center pumpkin
Dual tanks with a change-over valve
Swing pedals
Mechanical, but custom, clutch setup.
Dual master brake cylinder
Disc brakes in the front
Drum brakes in the rear (likely 11″)
Full Roll cage, though mounted to the body and not to the frame
Soft top
Serial number likely based on the previous L-head 4 cyl engine
Custom rear bumper

Continue reading →

Looks like a good price.

https://seattle.craigslist.org/sno/cto/d/mountlake-terrace-1950-willys-cj3a-jeep/7512991843.html

“1950 CJ-3A. Affordable project jeep. Original drivetrain. 11” brake upgrade. New springs shackles and hangers. Exhaust and shocks also replaced. Fold away spare tire mount. Tow bar. Extra military wheel set.
Contact me with serious questions. Clear title in my name. Not taking offers. Price is firm.”

This includes a rear PTO, gearbox and shield.

https://sanantonio.craigslist.org/cto/d/bulverde-1949-jeep-willys-cj-3a/7510917025.html

“1949 Jeep Willys CJ3A. Power PTO on rear end, factory bed extender, all original. We are only the third owner. Runs great and in excellent condition.”

Only the one pic provided.

https://tucson.craigslist.org/cto/d/tucson-1950-willys-cj3a/7506882317.html

“I have my 1950 Willy’s 4×4 CJ3A for sale for 6,500.00 OBO. It starts up and still runs. Original engine, tires good, does have an oil leak. Cosidering the year it is in good shape. Dont know the miles for sure as odometer is broke”

This is the third Ford 4cyl engine powered jeep I’ve listed today.

https://www.facebook.com/marketplace/item/882885109138413/

aho4-488×650.jpg” alt=”1951-CJ3A-hayden-idaho4″ width=”488″ height=”650″ />

“Buy it before I change my mind… 1951 Jeep Willys. Great running rig with a 2.3l Ford pinto(Lima) motor swap to the factory transmission and transfer case. Went thru last summer and replaced almost all seals on engine, transmission, transfer case and axles. Upgraded to power steering and telescoping steering column. New front seats and added a center console. Custom rear bench seat with integrated aluminum fuel cell. Continue reading →

If this runs and drives, it could be worth a look.

https://www.facebook.com/marketplace/item/3208582949414051

“I’m selling this Jeep for my dad, it’s a 1951 cj3a… The truck is a frame off restoration has 1 mile on it, motor has been rebuilt, Tranny, rear ends, all the wiring gauges, even the steering wheels been refinished, it’s four-wheel-drive, truck is completely brand new, needs minor work to complete, for more information please contact my dad at [hidden information] his name is Anthony, it will be a fun vehicle for whoever buys it this summer”

UPDATE: **SOLD** Was $10,000.

This looks solid.

“Rare 1952 jeep Willy’s ground up restoration runs and drives also has plow 4cylinder 3speed new roof no rust new price this is a great buy”