emailNeed to contact me and don't have my email? Click on email button.
About eWillys
Welcome to eWillys.com, a website for vintage jeep enthusiasts. I update this website nearly every day with jeep deals, jeep history, interesting reader projects, jeep related info, and more.
These quick searches can help you find things on eBay. People list in the wrong categories all the time, so don't be surprised to see brochures in the parts area for example.
The links to posts below show jeeps grouped by models, condition, and other ways. Some of these jeeps are for sale and others have been sold. If you are unsure whether a vehicle is still for sale or not, email me at d [at] ewillys.com for more info.
Importantly, the allure of buying a project jeep can be romantic. The reality of restoring a jeep can be quite different, expensive and overwhelming without the right tools and resources. So, tread carefully when purchasing a "project". If you have any concerns about buying a vintage jeep, or run across a scam, feel free to contact me for help, comments or concerns .
UPDATE: I received some pics from the seller. The holes aren’t all that bad (I’ve dealt with worse), but the right rear wheel well has seen some stress. I’d have to look at that much more closely. I believe the body is the same as my old jeep, which was a light duty body. The good news, the area over the transmission looks like it’s hardly been touched. This is usually cut up.
“1951 Willys Jeep CJ3A Flat Fender. Original 134 cubic inch L-Head “Go-Devil” motor that was completely rebuilt top to bottom by a well-known professional establishment in Sumner – Bow Tie Performance -. It was pulled, rebuilt, and then all the accessories were replaced too: brand new fuel pump, water pump, plugs, wires, cap, rotor, oil filter, all fluids replaced, new motor mounts, new lines and hoses, carburetor rebuilt, sprayed with high temperature paint and runs like a dream. The transmission is the original 3-speed T-90 which works great clutch and throwout bearing were inspected and did not need replacing, new transmission mounts too. The transfer case is an original Dana 18 twin-stick. Frontend is the Dana 27 open with original lockout hubs. The rear is an offset Dana 44 with a limited slip. ….”
I’d like to take a closer look at this one. I suspect this might be an ambulance or troop carrier of some kind.
“1948 willys jeep with a Ford bronco v6 engine. Was running and being used when an axle broke. Has been parked since, about 10 years. Comes with lots of extras including tranfer cases, transmissions, a hard and a soft top, blade hardware and odds and ends.”
Brian took a break from his CJ-3B and ran over to the Mounds ORV Park with his niece and nephew. In the pic they are showing off their ‘guns’ and their dirty jeep.
Brian writes, “Mathew came out from Seattle and was instrumental in helping me replace a blown 300 transfer case to get it ready to play.
We got to the Mounds ORV park around 11:00 am. located just north of Flint Michigan. This was my first time in the park. I am not really a big fan of mud and water and was happy that it hadn’t rained for a week or two. The park was surprisingly empty, given it was a Friday. There were only 3 vehicles in the park and about 15 motorcycles. We stayed in the park for 5-6 hours and played. It was great fun for the kids.
There were plenty of places to explore in the mud and, yes, I did get stuck 2 times in mud holes, using my winch to free myself. I quickly became friends with Ron and his family, while my winch line got to meet his late model Wrangler with open rear ends. I quickly discovered this really was not a place to be by yourself without lockers and a winch.
I found four ways to play: 1) Abundant standard mud hole’s, 2) A five acre treed area with winding tight trials called “Pines”, 3) A water hole in the scramble area 1 and, 4) a man-made rock crawl area.
Scramble area 1 is sand, something like Kitty litter, so I tested the water by running the sides then ran the short way through the middle. Not thinking it was deep and only 50 feet long at the most, I decided to hit it the long way. At the 3/4 point my left tire dropped in a hole and the top of the fender disappeared. My Niece McKenna, sitting in the front seat, said “there is water coming in”. Looking down it was only four inches of water; Looking up we had slowed to a crawl, wet, and laughingly chewing our way through the mud hole, sounding like an old Chris Craft.
Keeping my foot in it, Mathew, who was sitting in the back ,was thinking he was not going to get wet. However, to his surprise, the last five feet ascended out of the hole quite sharply, throwing the water to the back of the jeep and soaking Mathew’s butt. I don’t know how it got in the jeep but there was an inch of sand/kitty litter in the jeep. That hole was a lot of Fun!
The man-made rock crawls were about 300 yards that my 33’s navigated quite well. Mathew, being a newer licensed driver, was chomping at the bit, so I let him do some rock crawling and tight pines driving. He did quite good in both areas and shows a lot of potential as a Jeep driver. I was quite proud he learned to keep his foot off the gas. Below is a link to his claim to fame.”
Either the pics have been heavily compressed or a texture was added to the outside of the body.
“all original, almost totally rebuilt body, newly rebuilt engine with less than 100 miles, fully documented parts-upgrades-repairs since my ownership, serious offers only with delivery up to buyer–may consider Harley trade.”
I can’t tell if this is a road ready jeep or still a project, though I think it’s the latter.
“I have a 1948 Willys CJ-2A civilian Jeep. The Willys is a project meant for that one person that has the time and passion to work on it. I myself have spent endless amounts of time,money and passion into it. Due to college expenses I do need to sell it, I will only sell it locally and if you are out of state I would love to make arrangenents to conclude a deal here at my home. I do have a pink slip in hand. I have done alterations to the jeep myself here is a brief list:….”
“This is a 1948 Willys Jeep CJ. It ran good when it was parked about 4 years ago, not running now. Good start on an early Willys. I will deliver for free in the Albuquerque/Rio Rancho area. Body is pretty good and floors are decent too. All there and has title. It is a project and will need some work. Upcoming out of state move forces sale. $950”
“HAS HIGH, LOW FOUR WHEEL DRIVE, REAR PTO WINCH, LIKE NEW TIRES, STARTS, RUNS AND DRIVES GOOD. NO FRAME RUST BUT BODY RUST. YOU CAN’T BUT AN ATV FOR THE PRICE OF THIS JEEP. MAY TRADE FOR GUNS LARGE DEER ANTLERS. PHONE 740 528 3019 TILL 10:00 EST.”
Here’s a great looking slat grille. It’s not 100% original, but is in excellent condition.
“This is an awsome early (less than 7% of the total war time production) Willys slat grill MB! It’s date of delivery is January 2nd, 1942 and the matching frame & dash data tag list it as serial number “108808” It’s has the body tub features peculiar to these early jeeps like the script “Willys”on the rear panel, square shaped fuel tank well, no glovebox on the passenger’s side dash, and dual hinge rear tool box lids. The fuel tank’s the correct “small mouth” and the windshield, seats, hood, grill, baffles…all of the body parts…are original correct slat grill components. It even has the correct “fluted” inner axle shafts that are always missing, the cast windshield hold down clamps, and the early “pancake” style air cleaner. This is a genuine early slat grill jeep!….”
With my son Karson’s help, I got everything ready to fire-up the engine. So, we flicked on the switches and he pushed the button … and nothing. Such is the wonderful world of projects.
So, it was time to start testing parts to see what I did wrong. First, we discovered the start button was bad, so that was replaced. Then, I realized I had a loose wire, which we repaired. But, the biggest issue I had was that I wired up the Starter Relay (aka Starter Solenoid depending on the source) incorrectly. That took a little rewiring and refiguring (see revised schematic two posts above), but we did it. Then we tried the start button and success, the engine turned over without any unexpected noises!
Next, I realized the fuel pump wasn’t working. However, it turned out to be another wiring issue and I got that resolved.
We got to the point where gas was getting into the carb, spark was reaching the spark plugs and the engine was turning over, but it didn’t fire.
The next step was to more closely check the timing. While taking off the spark plug off the number one cylindar, the spark plug broke. I’ve never had that happen before. At that point it was 10pm and we couldn’t run to the store to get another plug. That was dissapointing as I had to take the boys home the next day (yesterday).
The good news is we got really close. It is nearly ready! I’ve promised to get video of the engine running so they can hear it (which of course I’ll post here as well).
Best of all, though, was watching 15 year old Karson get excited about working on the jeep. He was asking to go out and work on it, he waited patiently for things to do, and asked questions when he didn’t know what he was doing. That experience alone is worth everything I’ve put into this crazy project.
It’s a project. However, the body looks reasonably good still.
“Great 1942 Ford Geep GPW project that needs finishing , new rebuilt buick v-6 , 70’s jeep cj-7 axles front and rear , good solid body , but does need some body work and finish work to get nice . will need some wiring , steering assembled , fuel tank ,and small stuff to get running , good title with new dash data tags already made , tons of parts , new hardware and springs , from the orig guages , steering colmn ect… Great project for somone to finish as a crawler or bring it back to orig with out too much trouble $1700 as is or $1900 with orig front rears . This will be parted out soon if no one is looking for a project , I will keep the body and frame and sell everything else ….let me know if you are looking for parts .”
I couldn’t resist posting this unusual and modified jeep.
“I bought an old jeep to restore but it has not happened and I have owned it for over a year. Its stock with a modified bed with safari seats. I just need it to go to a good home so make me a deal and it will be yours. I paid $500 over a year ago. I am ready to sell for scrap so come get it… make me an offer. Ask Questions and I will answer what I can. Thanks.”
“1951 Willy’s Jeep CJ3A Flat fender Ford 4 Cyl. Pinto Engine. New soft bikini top, maroon color. Nice stock jeep with no rust, runs good, cb, with rear seat, newer black & red interior, seats four comfortably. Willey’s logo is on tailgate.”
To say this is ‘all original’ except for the running gear struck me as strange. It would seem there would have to be a variety of updates to accomodate the running gear.
“it is all orignal except the runing gear. i put chevy 1/2 ton in it, i had them narrowed to keep the same look of the jeep, i still have the orginal front end. it also has a custom roll cage 33s but it will fit 38s all it needs to run is fuel lines and fuel pump”
UPDATE: I’m a little surprised this hasn’t been purchased already, but maybe the project is bigger than it appears.
This might be a good price.
“This is a 1943 Military Ford Jeep GPW vehicle. My father purchased this Jeep with hopes of restoring it to it’s original state. Unfortunately we have other vehicle and rental projects and just do not have the time. This a really a great Jeep and a classic. This is a perfect vehicle for someone looking to have a project and make it their own. The Jeep is in need of some rust repair and the installation of a new timing gear and timing chain. My Father has already purchased a new timing chain, timing gear, new transmission knobs, and new U-joints for the jeep and are all included in the sale. The jeep also comes with an spare engine, gas tank, tire, and a complete jeep manual booklet. What’s great is that they still make every part for this jeep. This is a great jeep and ready to be taken good care of. The price is firm only because we believe it is a very good deal and considering the jeep comes with a spare engine and the other parts mentioned above. If you would like further information regarding the jeep you can reach my father at 206-947-8153 and myself at 206-999-3809.”
A running, driveable, not too bad looking CJ-5 for only $800. It looks like a deal to me.
“looks and runs very good needs some minor tlc but for the year its pretty nice and all the canvas doors and top are new. this is a fun little jeep its the cj5. Call robert
631 885 2551”
“Up for auction is a 1946 Jeep Willys CJ 2A. The vehicle is mostly original except for the engine, which is a fuel injected Chevy V6 out of an S10 pickup. The engine probably has less than 50,000 miles on it, but I dont know for sure. The frame is straight and the body is in pretty rough shape in my opinion, although not bad for its for its age, has some rust spots, nothing all the way through, and has also had some paint and body work as well, which I did myself, so its not perfect….”
UPDATE: this jeep sold and is on it’s way to California.
Here’s an unusual find. A garage kept, completely original Tuxedo Park CJ-5 with only 67,500 original miles. It’s been garaged in Montana since new, garaged in Washington the last four years and serviced every year.
This seller makes a valiant attempt to disclose all that is wrong with this jeep. How about those ‘hood blocks’?
“Up today is a 1942 Willys MB Jeep.This was a BUBBA special,You know BUBBA dont you? He puts the wrong tub on the Jeep,Then to add insult to injury he puts a big roll bar and the standard do not fit junk bucket seats and there you go. Well the roll bar and the seats were the first to go.Here is what you have. The parts that are mb are as follows.Frame with MB tag and s/n,Front fenders,grill hood front axle. What is cj are the tub and engine and the rear end. I do not know about the trans if it is mb of cj.Eng runs pretty good and has good oil pressure,It does smoke a little. The 4 wheel drive seems to work ok in the high and low range ….”
The seller claims this is in restorable condition, but it looks like there’s quite a bit of edge rust.
“1958 Willys Jeep CJ3B. Needs to be restored. All original condition except 12 volt alternator, tires and wheels,roll bar and seats. $1000 or best offer.”
