UPDATE: **SOLD** Was $3000

Lots of mods have been done to this jeep.  Though it sits a little high, the outboarded springs in the back should help improve the road stability.

“This is a 1946 Willys body on a Chevy frame with Chevy 350 four speed and drive train as you can see in the pictures. We did not clean or candy coated anything so that you can see what you are buying. This vehicle was bought about 3 years ago for hunting, off road and to be driven when ever and where ever. It doesn’t smoke, knock, shake or make any kind of noise and will take you any where you want to go. We don’t know what the milage is the odometer never worked.”

UPDATE: **SOLD** Was $1000.

It looks like some remanents of bondo on the back driver’s quarter of the body.  Otherwise, the body doesnt’ look too bad for a parts jeep.

“Selling as a parts Jeep with no title pics show the status willing to trade for ? let me know what you have”

This CJ-3A appears to be in pretty good shape.  I’m not a huge fan of the big bumpers, but not too bad otherwise.

“Engine updated to 289 V8, chrome wagon wheels with new tires, original seats 2 front and 1 rear bench, roll bar, red paint in fair condition. No vinyl top. Call 402-669-2675, leave a message if we don’t answer.”

http://denver.craigslist.org/cto/986873711.html

UPDATE: **SOLD** Was $7400.

“I purchased the Jeep in August of 1997. It already had the small block Ford in it but was just sitting in outside storage here for years abandoned. Loved it at first sight. I tracked down the owner and made him an offer after I changed the oil, put a new battery in and fired it up. It just purred. I put in my garage until about 2000. That’s when my father in law gave me a nice place to work on it…. “

The paint job makes it difficult to tell, but it looks like the side panel on the driver’s side is a bit rough (rust?) at the bottom edge.  The top sure fits funkily …

“Great 4×4 vehicle! This Jeep has a v8 small block 283 2bbl carb. 1,600.00 obo for more info call(530)432-9277 (ask for steve) or e-mail sjdana@live.com”

http://sacramento.craigslist.org/cto/982923519.html

The body looks wee bit rough, but it sounds as if the drive train will get you where you want to go.

“Its a 48′ Willys CJ2A that has the following: Full roll cage, RCI 5 pt. harness with seats, and quick release steering wheel. The engine is a chevy V-6 4.3 with power steering and 3 speed tranny. The suspension is Rusty’s leafs and shocks, around 6″ of lift. Front axle is a Dana 30 with super lift hubs and rear axle is AMC 20 with 1 piece axle shaft. Both have 4.88 gears and lockers. It has 4 wheel disc breaks, steel braided lines, and custom drive shafts…”

http://bham.craigslist.org/cto/983015882.html

Here’s a good looking, fairly stock CJ-2A.

“1948 WILLYS CJ2A FOR SALE. CLEAR TITLE, RUNS GOOD, CAN BE LICENSED AND STREET DRIVEN. ASKING 3000.00 OBO”

http://kansascity.craigslist.org/cto/980950087.html

UPDATE:  This sold for $4,995 on 01/11/2009 on eBay.

This CJ-3A only reached a high bid of $3,550 during the last auction attempt. I was a little surprised by that, but it’s also not been restored to ‘original specs’.  It looks nice and is back on the auction block.

“1949 CJ3A in extremely good condition.  It has be in body off restoration for 13 years striped to the frame.  It had the usual rust in the floor pans, new steel was welded in these areas. Also new under body rails were welded in. The frame was in good shape and the floor and the rear fender well are in good shape.  After the body tub was completed and before installed on the frame it was completely undercoated with a rubbery undercoat. Both front and rear axles were completely disassembled and rebuilt….”

View the many pics on eBay