UPDATE: Still Available.

(09/20/2020) This is being sold by the folks at Quarter Ton Parts.

https://www.facebook.com/marketplace/item/2162504230561291

“1952 Willys CJ3A. Runs good, Drives good, Stops good, 4×4 works fine. Lots of new parts installed. Rebuilt starter, new fuel pump, carburetor, Master cylinder, plugs, wires, tune up parts, sheering wheel, and steering bell crank pin and bearings. This would make a great parade or farm jeep. It would be an excellent restoration project. There is some bondo here and there, it pops out of second gear when you let off the gas and use the gears to slow it. (typical) It has leaks and some play in the steering. (All very normal for one of these) It is available if it is still listed. It is located at Quarter Ton Parts in Chickamauga, GA. Hours are 8-4 eastern M-F.”

UPDATE: **SOLD** Was $650.

Appears to have some value.

“1951 Willys CJ3A Rolling Chassis, 23,000 miles with title and tags, engine disassembled 30 years ago, been sitting in a garage ever since. Frame is very nice, front horns good, with axles, trans, transfer case, most engine parts, great start for a resto or drop in a 4.3. Lots of extra parts, bring a trailer and cash”

UPDATE: Price dropped to $3000.

(11/02/2020) I’m not sure which winch that is.

https://www.facebook.com/marketplace/item/777351596158371/

“Willy’s Jeep. New brakes. New fuel pump. New rear seat. Has soft top with bows and doors. No trades. Price is negotiable, but not giving it away”

This uncompleted project has a variety of mods.

https://www.facebook.com/marketplace/item/3384097468310603/

“1949 Willy’s tub, 72’ CJ boxed frame, Scout Dana 44 front axle, J20 Dana 60 rear axle, 5.13 gear ratio with lockers front and rear, 94’ 351 Windsor EFI, 86’ NP435 full rebuild with Novak adapter to Dana 20 transfer case, Dana 20 twin stick with 4:1 gears and full rebuild with advanced adapters output shaft, 36” TSL Swampers on DIY bead lock wheels. This is a project and needs to be finished/ reassembled, make NEW motor, transmission and body mounts etc. I have the title and it is licensed as a horseless carriage, might consider trades or best offer.”

Drain holes have been filled, so likely has had body work.

https://missoula.craigslist.org/hvo/d/missoula-51-willys-jeep/7226934290.html

“very nice restored willys jeep call fore detail”

UPDATE: Price dropped to $4500.

(05/18/2020) Runs and drives.

https://www.facebook.com/marketplace/item/2537262899921928/

“Good condition for a1951. Will consider all offers. Just had complete tune up. Runs good!!.”

This is listed as a 1944, but is more likely a CJ.

http://www.sellajeep.com/mjs/sale20/adm219/adm219.html

“It has been stationary for 20 years. Must go. Good for parts. Front Tow attached. In Central California, Los Alamos – 1 mile off Hwy 101. Come get it!!”

Seller is keeping the body and VIN and selling the rest (mostly sounds like the power train and chassis).

https://www.facebook.com/marketplace/item/657991271571370/

“I’m selling everything but the cab/tub and everything in it. I will be keeping the VIN and title. May also keep the radiator. I’d like to sell the frame, rolling on axles with the engine, transmission, and transfer case as one complete unit. It’s a 1953 CJ3A with a V6 swap. Not sure if it’s an odd fire or not. I drove it to where it’s been parked for about a year. I believe the master cylinder needs to be replaced. I’ll try to get it running for a serious buyer before I remove what I’m keeping. If you have any questions, feel free to ask. $1000 OBO”

Looks in very good shape. The hood is likely aftermarket as it lacks the Willys stamps.

https://miami.craigslist.org/mdc/ctd/d/hialeah-jeep-willy/7220000823.html

“1952 willy nice”

Unclear how much value is here, but it looks like the body has been rebuilt.

https://lakecity.craigslist.org/cto/d/dunedin-1950-willys-jeep-project/7220624892.html

“Selling or will trade for motorcycle or jet ski. Built in my garage in Colorado. Moved to Florida and do not have a garage to reassemble and finish. 350 Chevy small block 4 bolt main. Lots of metal restoration, front fenders and grill are perfect. New frame rails, floor pans, leaf springs, shackles, Rancho 5000 shocks. Original 3 speed manual transmission, replaced input shaft to adapt to Chevy bell housing, needs steering and pedals. Have all original parts.”

UPDATE: Price dropped to $800.

(10/19/2020) A couple things with the seller’s notes. I agree this appears to be a CJ-3A, but the Dana 44 was introduced in late 1950 to the CJ-3A (not 1952).

https://victoriatx.craigslist.org/pts/d/victoria-willys-jeep/7220220622.html

“Was converted to chevy V8 and front saginaw manual steering (excellent upgrade if you’ve ever driven a stock one). Has 16” wheels and one of them appears to be original (date stamped 1953 military) it will need a replacement engine as the v8 block in it is apart and no good any longer. Jeep is rusty, modified, old and in need of extensive repair and restoration but is mostly all there. I do have the front fenders, they were only taken off to pull the engine out but I have lost interest and have too many other projects to finish first.

The firewall was butchered when the engine conversion was made but wouldn’t be too difficult to patch and repair with sheet metal and a little effort. Asking $1200, it has no title and I am not sure what year or model it is, my best guess 1953. It has the dana44 rear axle (means it is at least a 1952 and they quit building the low hood in 1953 and the gear ratio is 5.38:1 like most of them were throughout the years. It rolls easy but should be trailered because of age.”

Has a least a few mods.

https://fresno.craigslist.org/cto/d/fresno-jeep-for-sale/7215871414.html

“1951 Willys CJ3A Engine is 1962 Chev. 327 w/double hump heads, 4 sp. truck trans. Excellent body, for details, contact me. No trades, serious buyers bring cash.”

UPDATE: Price dropped to $5500.

(05/24/2020) This has a variety of mods.

https://sfbay.craigslist.org/nby/cto/d/napa-1953-willys-jeep/7216271357.html

“1953 Willy’s Jeep Flat Fender
Clean title and registration
4wd
289 V8 Conversion
3 speed manual transmission with overdrive
Dual exhaust
Power steering
Locking front hubs
Dual fuel tanks
Carb rebuilt within last year
Front tow bar
Spare set of stainless steel front fenders included

Runs strong. Used primarily for hunting. Only parting with it due to lack of time.”

Seller’s title labels this a 1945, but it looks more like a 3A to me.

https://tulsa.craigslist.org/cto/d/okay-1945-willys-jeep/7213895587.html

“1945 Willys Jeep barn find. All original 4 cylinder engine and running gear. Engine will run but not sure about the running gear. Looking for best offer.”

UPDATE: **SOLD** Was $10,800.

(10/04/2020) Seems like it could be a very late 2A or early 3A.

“Jeep CJ3A. Original Willys from the 1940s. Super Quite 4 Cylinder Engine. Dry Wyoming 4×4. Been in the same family 40 years.Hauled many Deer and Elk out of the Mountains. Runs like a watch. Idles Smooth. Original Trans and Transfer Case. 4 750×16 tires and a good spare. This is Absolutely the Best almost no Rust Jeep CJ I have seen in 30 + years. Look at the Pictures. Warn Hubs, Windshield wipers. Dual tanks with a valve. Good old style Tow Bar. A military style rear jump seat. This is what your Grandfather and Father loved to take Afield.”

UPDATE: Still Available.

(12/09/2019) Has an F-head.

https://phoenix.craigslist.org/evl/ctd/d/mesa-1952-jeep-cj3a-suv/7212638797.html

“Pictured is a 1952 4X4 Willys CJ3A in very good condition I keep it inside and it comes with a Kaiser metal hard top. It is registered, insured and I drive it a few times a month. I just gave it a tune up: oil change, greased, plugs, plug wires, carburetor rebuild, rebuilt the cooling system (radiator professionally cleaned, repaired, painted), replaced cooling lines and replaced water pump and fuel pump. This jeep has the higher powered F134 engine in it out of a CJ3B.”

UPDATE: **SOLD** Was $2000.

I’m not sure how much value is here.

“53 wilkys jeep project. Its a good start have toyota axles and a 302 Ford engine and trans. Have adapter to the Toyota t-case. The motor was ruffed into place. The tac welds broke when it was moved. Its a project. Have title in hand.”