Has some mods, including redone floors.
https://www.facebook.com/marketplace/item/2016746438665096/
“1953 3B Jeep Willy’s V6 Buick motor. Clean title”
Has some mods, including redone floors.
https://www.facebook.com/marketplace/item/2016746438665096/
“1953 3B Jeep Willy’s V6 Buick motor. Clean title”
UPDATE: **SOLD** Was No Price.
This looks like a solid build.
“1949 Willys Delivery, sitting on a 1998 s-10 frame
350 engine/ turbo 350 transmission, New Power Steering, Disc Brakes, Power Brakes, tilt steering column, Lokar Shifter and emergency brake handle and brake lines. New wiring and gas tank. New glass, interior. and a whole lot more, to much to list
might be willing to trade for a toyota full size 4×4 automatic truck”
The body looks relatively untouched. There seems to be some value here. Price includes the trailer.
https://reno.craigslist.org/pts/d/reno-1946-ford-military-jeep-flat/7639642163.html
“46 military jeep project complete Buick V6 ,automatic transmission with overdrive, transfer case , Archer Brothers tub many extra pieces 3 grills, 2 sets of fenders one set new, three hoods, one New, one fiberglass, 1 solid windshield 1 New two piece windshield ,New tailgate, New fuel cell
includes trailer $2500 firm takes all possible trade”
UPDATE: Price dropped to $7200.
(08/15/2022) It appears fairly stock. Some better pics would be great.
https://oklahomacity.craigslist.org/cto/d/prague-willys-cj2a/7633781488.html
“Drive it away! Oklahoma Tagged. Clean Title. Street Legal.
1946 Willys CJ2A jeep. 1-1/8 intermediate shaft. 12 volt alternator, steering modifications, Warn Overdrive, Warn Hubs. 11″ Front Drums otherwise stock.. engine starts well.. transmission shifts well. 3 sp T90 and Spicer 18 Transfer case. Go Devil 134 cid engine.
Runs well.
Cash only. No trades.”
There could be value here.
https://www.facebook.com/commerce/listing/280875391132606
“Early 46 cj2a for sale , needs a new tub , the rest is great . Engine does not turn $950”
Andy spotted this low-cost trailer. Seems worth a look.
https://www.facebook.com/marketplace/item/823855469326968
“Ball hitch trailer. Top rim of the trailer is 4 foot by 6 foot long. The hitch is an additional two feet. Floor has some holes along the edge and one tire is flat.”
This could be worth checking out if you have a Jeepster with a bad body.
https://wichita.craigslist.org/pts/d/wichita-restored-1950-willys-overland/7639118948.html
“Restored body only. No title, no motor, no transmission, no interior, no top, Does have axles.”
This might be worth a look if the body is as solid as advertised.
https://eastoregon.craigslist.org/clt/d/mount-vernon-1956-willy-jeep/7632677944.html
“Selling the 1956 willys jeep wagon , good glass ,very little rust ,body in good shape for the year . Has a chevy 283 but needs distributor work to run ,3 speed tranny , good hubs , good four wheel drive . This would make a great project as its in great shape for its age .Does have a clean oregon title . Please call the number provided as i won’t text or email. Thanks”
Looks like there is value here.
https://denver.craigslist.org/cto/d/parker-1944-ford-gpw-project/7636352644.html
“1944 Ford GPW – AS IS. Warhorse project.
Extra parts/missing parts – has a WOF flat-head. If you have any question – let me know. (Text/Email) I’ll answer as best I can.
Just to clarify, this is a project and is in non-running condition.
Please ask any and all questions. I’ll do my best to answer.
Thanks for looking.”
UPDATE: **SOLD** Was $4000.
Looks like a good price.
“1942 Ford GPW, Willys jeep, WWII
Make a reasonable offer.
Tan
Modifications:
V8 engine (extended engine compartment)
T10 Transmission
Roll bar
Mechanic special
Off road vehicle – not for city driving
Tires are newer, but flat. You’ll need an air compressor to air them up. There’s power at the storage unit so you can plug something in. It should start. It’s only been sitting a year. I recommend having it towed/trailered anyway.
I am devastated to lose this. I grew up with it. My father made most of the modifications to it. It was our fishing/camping vehicle.
My boyfriend just passed and I can’t keep it. I want it to go to someone that will love it and use it.
I’m available Sunday to meet.”
I HAD planned on doing posts for this morning, but yesterday we discovered water near our water tank, which soon lead to discovering one of our pipes (in a wall) was leaking. So, holes were cut in the wall and leak verified (at copper corner piece joint). Several hours and one trip to Home Depot later, I was able to get everything fixed (thank goodness for push joints). Whew.
In lieu of updates, we’ll celebrate Roger Martin’s newest acquisition: A 1960 Howe-modified FC that was formerly in the Toledo Firefighters Museum. It run and drives and is in great shape! Congrats Roger!
I am typing this while recovering from a wasp sting that caused my right hand to swell (it’s been an odd health year for me!), which sent us to the local doc-in-a-box to get some steroids, which in turn helped reduce the swelling (after 24 hours). I’ve never had a reaction to a stinger like that, so it’s a bit of a surprise!
Last week I finalized the body mounts. Hinges attach the body to the back of the frame in two places. Two single bolts with large washers hold the mid section of the body to a plate on the roll bar. And, two bolts through angled aluminum hold the bottom front portion of the cowl to an angle piece on either side of the body. On the upper portion of the sides of the cowl some rubber taped to the inside of a bracket keep the cowl from shifting back and forth.
The front clip is proving a bigger challenge than the body. First, I had to cut out part of the the driver’s rear-side portion of the front clip because it was too narrow and hit the side of the body. So, I am creating a form and will lay some new glass down (along with patching a few other places).
Then, once the hood fits properly, I will have have to build special mounts for the front clip. The goal is to reduce the stress on the hood, as these things are often mounted with quick release setups that allow the body to flex, making it more prone to breaking and cracking and/or rubbing on the body.
Here are a few pics:
I decided to to throw a couple blocks (made from some of my grandfather’s wood) onto the hood that are a nod to the original hood blocks, but will also tie in a frame underneath the hood to help support and mount the front of the hood.
You can see part of where the hood is cut out. The form will allow for the new portion of the hood also down fender to flare outward more (or that’s the plan).
During a roadtrip with family, Mike spotted this unusual jeeprod with a UFO topper on it, cruising in Roswell, New Mexico. The plates indicate the rig is from Texas.
After failing several times, I finally won a copy of this Hatari-themed jeep brochure. It is from number DM 62-03. Learn more about Hatari and Jeep at the CJ-3B page.
Here’s the front page of the brochure:
It opens horizontally to show this two page Hatari announcement:
It agains open up horizontally, both to the left and to the right, to reveal several different vehicles that appear in the movie, including a truck, a CJ-6, a wagon, and an FC-170.
On the back side of the brochure are some of the actors that appear in the movie:
I won this Al-toy on eBay recanted for only $39. It has a slightly broken bumper on the passenger side, but otherwise seems in good shape.
UPDATE: **SOLD** Was $10,000.
This appears solid and has the Kubota diesel engine swap.
“1947 Willys Jeep CJ2A 4 cyn Kubota Turbo Diesel. Runs excellent, 3 speed trans, 8,000 lbs warn winch, synthetic rope w/remote. Brand new Cooper Tires & brand new Bassett Beadlocks & front disc brakes. New rear axle shafts, bearings, backing plates & brakes. New Best Top (Soft top). 3 extra front axles. 2 extra rear axles. Alum. top with doors. Lots of extra misc parts. Clean Idaho Title. Gets excellent fuel mileage”
Tom spotted this dually. It appears in good shape.
https://www.facebook.com/marketplace/item/654852506490968/
“64 Willys with a new rebuilt Hurricane engine, 3 speed manual high/low transmission. Steel body. Everything on this Jeep new or rebuilt. Excellent condition. Also comes with a new soft top/with doors $1000 dollars”
Bill shared this nice looking CJ-3A that took a hit on the driver’s side, front end. OUCH! The jeep is up for auction via copart. I bet the front of the frame is bent.
https://www.copart.com/lot/57391353/1951-jeep-willy-tx-amarillo
It looks like the rear area has been customized. Might be worth a look at this price.
https://www.facebook.com/marketplace/item/985154409342242
“V6 ran when parked 3yrs ago,needs restored.”
Seems worth a look, but needs at least some work.
https://www.facebook.com/marketplace/item/297770875939687
“1952 Jeeps Willy’s, will turn on and run but is bad for it,unfortunately it needs new breaks and a new intake manifold gasket, is leaking coolant into oil pan. Don’t have time to fix it, need it gone 5,000 or best offer.”
This is very much a project, but might appeal to someone given the short bed.
https://www.facebook.com/marketplace/item/6452431541505064
“55 short bed willys pickup on a wagon frame. Stock sbc 350 4 speed dana 25 front axle work dana 53 rear. You will need to trailer it. I was going to fix it up but just don’t have to time.”
UPDATE: Price dropped $9000.
(06/05/2023) The only pic provided suggests it is earlier than 1948. Not quite all original.
https://www.facebook.com/marketplace/item/1417401218801743
“1948 CJ2A Original Willie’s ”
UPDATE: price dropped to $3930.
(03/16/2023) Needs unspecified work.
https://www.facebook.com/marketplace/item/1180504129266965
“1953 Willy’s Jeep. Starts and runs. Needs to be worked on by a mechanic to get back on the road”
UPDATE: Still Available.
(05/02/2023) No engine included.
https://www.facebook.com/marketplace/item/2034467656762819
“Flat fender project. No motor.2000 obo. Extra frame. Has radiator, grill, fuel tank, windshield.”
UPDATE: Still Available.
(02/26/2023) This is a project, but looks to be a solid one. It’s got a Koenig hardtop.
https://www.facebook.com/marketplace/item/1544870496007149
“1948 flat fender willy’s jeep rolling chassis lots of new stuff new wheels tires hubs leaf springs shackles u bolts fender flares tilt column seat covers seats gauges carpet in back steering box shocks 2 different sets of seats and race harnesses list keeps going body bushings u bolts roll cage Project comes with a removable hard top u pick the power plant and trans asst it up how u want it yes there’s a title a but I will throw in sbc and ls block n heads too $7500 rolling badass condition”