Looks like a good project. It lacks an engine.
https://www.facebook.com/marketplace/item/522727621833632/
“1960 Willys CJ3 Jeep $3000 It does not have an engine.”
Looks like a good project. It lacks an engine.
https://www.facebook.com/marketplace/item/522727621833632/
“1960 Willys CJ3 Jeep $3000 It does not have an engine.”
UPDATE: **SOLD** Was $7000.
Appears solid.
“1954 Willys CJ3B 4×4 2nd year with the Hurricane, overhead valve motor. It has the flat fenders and taller hood. The previous owner had the motor rebuilt and the body is good. It has new seat covers, new water pump, electronic ignition, electric fuel pump, lock-out hubs and good tires.
There are seat belts for 4 and it’s street legal.
Could be restored, hot rodded or driven as is.”
There seems to be value here.
https://www.facebook.com/marketplace/item/731434977302152/
“2 CJ3B projects – lots of valuable parts -”
Will need some work.
https://elmira.craigslist.org/cto/d/wyalusing-jeep-cj3b/6974236874.html
“I have for sale a 1953 Willys Jeep CJ3B that is all original.
134 c.i. “F”head engine( first year for the overhead valve F head). Starts and runs. 6 volt system. Jeep has the original seats, soft top frame, heater. engine,transmission, transfer case. All original, nothing changed or ” upgraded”!
This Jeep has a 6′ Meyer snowplow with electric lift.
Jeep starts and runs, four wheel drive/low range works, plow works as it should.
Body has usual rust for a 66 year old Jeep and has been patched but is not beyond restoration.
I have seen and patched lots worse Jeep bodies. Tailgate was rusted off, I welded in a steel panel
Brakes need repaired but this Jeep can be test driven around my shop.
Clean Pa. title in my name.
Price is firm”
Appears solid.
https://albuquerque.craigslist.org/bar/d/corrales-1954-willys-cj3b-jeep/6972455566.html
“I have a 1954 Willys CJ3B jeep for sale or trade for tractor with a front end loader”
This former Navy jeep has a gov dash plate.
https://westernmass.craigslist.org/cto/d/chester-1953-jeep-willys-cj3b/6970744584.html
“I am selling a 1953 Jeep Willys CJ3b. Jeep is out of California until 2010 where it made its way to the northeast. Minimal rust, two spots the size of a 5 inch square on both floors by feet. Thats it.
The vehicle was undercoated many years ago, of which is peeling like crazy off the bottom of the tub and fenders. Literally comes off in sheets, by hand. Nice grey gloss paint underneath. That grey is the original grey and I think its called swan grey.
The motor was just gone through, including less than .002 taper on each cylinder, rods, pistons and main bearings are all standard and have never been over sized. Cylinders were honed and new standard rings were installed, only because the original rings had become brittle and I snap a few when removing.
UPDATE: Still Available.
(09/12/2018) Has a variety of updates.
https://seattle.craigslist.org/kit/cto/d/poulsbo-1953-willy-jeep-3b/6958581222.html
“1953 Willy Jeep 3B High Hood, with a 1981 Buick V-6 (odd fire) with GM bell and clutch, T 18 Ford truck 1 ton trany with a jeep split transfer case. Rear end is a 44 with flanged axel with 4-27?, Front is 27 with Thorenson 80lb mini slip with 4-27?. Steering is a Saugana power with Oldsmobile tilt wheel. Winch is a Warn 8000ld with remote control. New seats and the fuel tank is under the rear seat box. All new wiring and gages, rino type interior. All sitting on B F Goodrich All Terrain T/A 10R15 with gray eight spoke rims and manual hubs.”
UPDATE: Still Available.
(08/05/2019) Hasn’t been driven much in years.
https://sfbay.craigslist.org/eby/cto/d/sunol-willys-jeep-cj-3b-1953/6947526341.html
“I have a Willys Jeep CJ-3B that was stoed in barn for years. Engine runs fine, tire are in great condition (less than 100 miles on them), new battery, have a few extra parts. Engine is a 307 v8 Chevy, it is a 3 speed, has the overdrive kit, high and low 4 wheel drive.”
UPDATE: **SOLD** Was $1500.
Plow jeep with running V-6.
“1954 Willys CJ3B high top. Buick V6, 3 speed T14 transmission from a 67 CJ5. 33×12.50 Firestone tires. 7 foot fisher plow. Needs a throw out bearing. Runs great. Rough body.”
It’s a project.
https://www.facebook.com/marketplace/item/1461309987341945/
“Hello, I am selling a hard to find 1953 Willy’s 3b for my grandpa. He has had the vehicle since the 70s and has been a great vehicle for him. He started to rebuild the vehicle a few years ago but then had some health complications. It has all the parts for the vehicle. He has some new parts like a new gas tank, and a Buick 238 V6 that was rebuilt 3 years ago. It has lived it’s whole life in the desert so it has minimal rust compared to more humid environments’
UPDATE: **SCAM** … This ad appears to be a spam ad that was emailed directly to me (we even exchanged several emails). Neilwilson266 @ gmail.com, the email associated with the post, appears to be a spam email account (or has been co-opted) and has been linked with several spam emails to readers.
In addition, the jeep below has been priced at $3800 on WillysForSale.com for three months, listed by “Neil” as well. A phone number of 409 299 3478 has been associated with “Neil” …
The jeep below may well still be for sale in Tucson (see older ad here), but I can’t really tell what’s going on with it at this point. The photo below looks like Tucson, not Houston.
========================
“1953 WILLYS JEEP —-RUNS GREAT—— REBUILT—– NEW ITEMS INCLUDE; wiring, tires, shocks, gas tank, glass, seats, upholstery, top, hoses, gauges, brakes, exhaust system, 4 cyl engine rebuilt. asking price is $4,800 negotiable.”
UPDATE: **SOLD** Was $5500.
This is likely a J4 or J4C. It has a few changes, including an odd windshield modification and a WILLYS plate that appears added to the hood.
“I am selling my project jeep. Its a 1959 Willys cj3B/M606. It is an export jeep to Japan, assembled under contract by Mitsubishi and was later imported back into the US in 1981 ( I have most all of the original paperwork / has an oregon title and plates ). It is very clean, but needs finishing. Motor is rebuilt, new clutch, all fluids changed, all new brake lines, new fuel lines, new carb, new cooling system, converted to 12 volt with a 150 amp GM alt. New dual AGM batteries, all new cables, brand new disc brake master cylinder kit with proportioning valve. All new plugs, wires, rotor. New 6 point roll cage, all new stainless steel exhaust, newer seats, original Japanese canvas top, all original lights. Converted the front to a narrow track open knuckle 30 front axle with all new disk brakes, new bearings, seals, rotors, calipers, brand new spicer 5:38 gears in the box and new master install kit.
F134 Motor
3 speed trans.
dana 18 tcase
Dana 44 rear
Dana 30 front
5:38 gears
Jeep starts up and runs great, carb needs tuning. Great project before hunting season.”
Looks like a later model 3B.
https://maine.craigslist.org/grd/d/peru-willys-cj3b-jeep/6959578388.html
“Willys Jeep CJ3B. Runs, drives, steers. Body rough. No brakes.
Trade for tractor attachments like tiller, blower, bush hog, farmi winch, skidder, sawmill, case 310, dozer, crawler, grader, Fisher plow, greenhouse, shed, farm equipment, snowmobile, atv”
Lots of mods.
https://atlanta.craigslist.org/nat/cto/d/buford-1962-cj3b-willys-jeep/6953641871.html
“With great regret, I’m selling my little jeep that has been part of the family since new. I ended up with it in ‘07 and did the transformation to what you see
It has a 1995 4.3 with 90k miles on it, Painless wiring harness, NP435 transmission with Dana 20 twin stick that’s been geared lower, Dana 44’s out of a Scout II with 5.38 gears. It has a Detroit rear and an ARB front locker. It has a power steering box from a Scout II, and Hydroboost from a CUCV.
It also has 14” Fox air shocks all the way around with 37” red label BFG crawlers. I have a brand new pair Of PRP seats that go with it, it already has PRP 4 point harnesses installed. I have a fuel cell for it that I never installed also.
It has a Warn 8274-50 winch, aluminum radiator, xenon headlights, cage is all 120 wall DOM.
It’s completely street legal, has been driven all over the place, it’ll get down on the trails. It has great street manners. 3 link front and 4 link rear with Ballistic Fab brackets everywhere.”
It’s rough.
https://northmiss.craigslist.org/ctd/d/west-point-1953-willys-cj3b-jeep-barn/6961929639.html
“1953 Willys CJ3B Jeep Barn Find Motor will crank and run
1953 Model…looks like it began as some Military Vehicle
Its all there and all Original…I Told you all I know ..Come take a look
VIEW vehicle at Cooper’s Wholesale Cars 8041 Hiway 45 Alt North, West Point MS 39773 (next to Tin Lizzie)
View my website www.cooperswholesalecars.com for Toyota Land Cruisers, Tacomas , Tundras, 4 Runners”
Period correct restoration? It’s labeled as a “Jeep Willys CJ-2A”, but the seller also notes it has a cj3b 4-134.
https://phoenix.craigslist.org/evl/ctd/d/tempe-1953-willys-jeep-restoration/6961408254.html
“Ultra cool 1953 Willys Jeep older military style restoration period correct with extra attention paid to details an absolute must see to fully appreciate. It does everything just like was intended when new.”
UPDATE: **SOLD** Was $2200.
It appears there are two tubs, one of which is a replacement body.
“Jeep in pieces with lots of spare parts. This is a project I will never get to and would rather see someone else build it. I have everything except the fuel pump. According to the guy I bought it from it was running when he took it apart for restoration. The original color is rare Cadet Gray. It comes with many spare parts including a complete Koenig hard top and a complete aftermarket body kit. Have a title in hand.”
UPDATE: **SOLD** Was $600.
(07/11/2019) Has lots of mods.
“1943 Willy’s Jeep ( Ford ) . 327 Chevy V8, T-90 transmission , Dana 18 transfer case 29 tooth, power steering.33 x 12.5 Goodyear Mud tires. I bought this a few years back not running as a tinker project. I have had a lot of fun getting it running and fixing it up. I have been using it as a grocery getter around town and enjoyed the heck out of it. Like any Willy’s of it’s age it is not perfect but I have replaced quite a few things so you should be able to turn the key and enjoy.
Parts I have replaced (New) – power steering box, tie rod ends, steering column, new drum brakes, calipers and master cylinder , radiator , electric fan, front seats with 4 point harness, electric fuel pump, MSD ignition , LED head and tail lights, carburetor (3 years old), jerry can, one new fuel tank with sending unit.exhaust pipe and muffle replaced back from headers. New wiper motors and wipers.
Continue reading
UPDATE: **SOLD** Was $12,000
(07/10/2018) I’m wondering if the rear of the body was repaired using an MB replacement panel? I can’t remember seeing any replacement 3B tubs with a solid back.
“1952 cj3B restored to 90 percent original”
This might have some husky/allstate hubs.
https://catskills.craigslist.org/cto/d/hamden-willys-jeep-cj-3b/6957539590.html
“Willys CJ3B for parts . Drive train there . Body / Chassis bad shape .”
Could be a good price.
https://kalamazoo.craigslist.org/snw/d/kalamazoo-mitsubishi-jeep/6957815114.html
“Mitsubishi JEEP CJ3B , diesel engine 4 cylinder turbo, 4 speed, 4 wheel drive”
UPDATE: Price dropped to $2500.
https://sfbay.craigslist.org/nby/cto/d/hopland-1952-willys-m38/6954699090.html
“Re Posting my 1953 High Hood Willys. Had the listing up a few months ago but got real busy. Ran when I put in the barn ten years ago. Needs master cylinder for brakes which I have and did not put in. Been in the family since the 1970’s. Will need to be trailered to your location doesn’t run at the moment . Engine not locked up. Rust in various places and some dings. Would make a great teen summer restoration project. Can send you more pics if desired. Comes with a rare steel cab roof”
Not sure there’s much value here.
https://www.facebook.com/marketplace/item/2141763882612604/
“selling parts or whole”